Description: Here you enter interface configuration mode on a 2950 switch and make the interface protocol up. Choose 2950 switch by going to the network diagram, and selecting appropriate device.
Instructions:
1. Enter global configuration mode
2. Enter interface sub-configuration mode for Ethernet slot#0 and port#1
3. Shutdown the interface
4. Exit to privileged mode
2950>enable
2950#configure terminal
2950(config)#interface fastethernet 0/1
2950(config-if)#no shutdown
2950(config-if)#end
Note: Please refer to the SimulationExams.com Sim-Ex™ Lab Simulator for Network+ software to try complete lab with instructions.
Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.Network+™ is a trademark of CompTIA® organization.
