Q8. You are configuring EtherChannel on your clients network. What is the command for enabling load balancing using source IP address?
A. Control messages
B. Client data
C. DHCP requests
D. 802.11 beacons
Correct Answer: A
Explanation:
The command: Switch(config)#port-channel load-balance src-ip will configure load balancing on EtherChannel switch links using source IP address.
Note that the load balancing can be done based on source IP, destination IP, both source and destination IP (XOR), source and destination MAC addresses or TCP/UDP port numbers.
Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.CCNP™ is a trademark of Cisco® systems
