Description: In this lab, you will learn to enable interfaces on a router i.e, configure Serial 0/0 and fastethernet0/0 interfaces on a router with specified IP Address and Subnet Mask.
Instructions:
1. Enter into privileged mode
2. Enter into global Configuration Mode
3. Set IP Address of Serial 0/0 as 196.20.32.15 and Subnet Mask as 255.255.255.5
4. Set IP Address of FastEthernet0/0 0 as 195.20.32.10 and Subnet Mask as 255.255.255.10
Please enter FULL command. Kindly note that short form commands are not supported by the simulation software at this time. Type the commands and press enter or click ok button. All Commands are case sensitive.
For any comments / suggestions, please email webmaster[at]simulationexams.com
Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.CCNA™ is a trademark of Cisco® systems
