Description: In this lab, you will learn to Set keepalive Parameter of interface serial 0/0 to 15 seconds
Instructions:
1. Enter into Interface serial 0/0 config mode
2. Set keepalive Parameter of interface serial 0/0 to 15 seconds
3. Type the show command to see that keepalive parameter of interface serial 0/0 is set with 15
Please enter FULL command. Kindly note that short form commands are not supported by the simulation software at this time. Type the commands and press enter or click ok button. All Commands are case sensitive.
For any comments / suggestions, please email webmaster[at]simulationexams.com
Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.CCNA™ is a trademark of Cisco® systems
