Description: By default, an interface will be in shut-down state. We need to issue no shutdown command to bring-up the interface. Notice that the show interfaces command shows that the line protocol is up indicating that the interface is now active (sending and receiving packets).
Instructions:
1. View the information about interface serial 0/0
2. Bring serial 0/0 to no shutdown state
3. Now view the state of the interface serial 0/0
Please enter FULL command. Kindly note that short form commands are not supported by the simulation software at this time. Type the commands and press enter or click ok button. All Commands are case sensitive.
Disclaimer: Simulationexams.com is not affiliated with any certification vendor, and Sim-Ex™ Practice Exams are written independently by SimulationExams.com and not affiliated or authorized by respective certification providers. Sim-Ex™ is a trade mark of SimulationExams.com or entity representing Simulationexams.com.CCNA™ is a trademark of Cisco® systems
